Audi 3.0T Tuning Guide: S4, S5, A6, A7
Audi calls it the 3.0T. The engine covered here is the supercharged EA837. It has no turbo.
The newer EA839 has a turbo. It arrived in the US for model year 2018 in the S4, S5 and SQ5. This guide does not cover it.
This 3.0 TFSI is a direct injection V6 with a supercharger sitting in the V between the cylinder heads. The belt drives it, so there is no waiting for boost to build. From the factory it is smooth and quiet. There is a lot more in it.
The short answer, from GTS: we tune the 3.0T in the B8 S4 and S5 and the 2012-2015 C7 A6 and A7, all on the Simos 8 ECU, remotely through the OBD port. Stage 1 makes 438 hp and 370 lb-ft with no parts. Past Stage 1, every step starts with a pulley: a supercharger pulley for Stage 2, a dual pulley for Stage 3, up to 462 hp and 430 lb-ft.
Which cars have the 3.0T
Two GTS tunes cover it, split by car. All of them run the Simos 8 ECU. The 2016-2018 A6 and A7 moved to Simos 16, which we do not tune yet.
| Car | Years | Codes | Stock | Tune |
|---|---|---|---|---|
| B8 and B8.5 | ||||
| S4 B8 | 2010-2012 | CCBA | 333 hp / 325 lb-ft | B8 S4 / S5 tune |
| S5 Cabriolet B8 | 2010-2012 | CCBA | 333 hp / 325 lb-ft | B8 S4 / S5 tune |
| S4 B8.5 | 2013-2016 | CGXC, CTUB | 333 hp / 325 lb-ft | B8 S4 / S5 tune |
| S5 B8.5 | 2013-2017 | CGXC, CTUB | 333 hp / 325 lb-ft | B8 S4 / S5 tune |
| C7 | ||||
| A6 and A7 C7 | 2012-2015 | CGXB, CTUA | 310 hp / 325 lb-ft | C7 A6 / A7 tune |
| A6 and A7 C7 | 2016-2018 | CREC, CREH | 333 or 340 hp / 325 lb-ft | Simos 16, not supported yet |
The same supercharged 3.0T also went into the Q5 and SQ5, the Q7, the A8 and the 2009-2011 C6 A6. None of them is on a listing. Talk to us first.
Same badge or same car, different engine:
| Car | Engine | Go to |
|---|---|---|
| S5 coupe B8, 2008-2012 | 4.2 V8 | Talk to us first |
| S4 and S5 B9, 2018 on | 3.0 V6 with a turbo (EA839) | EA839 guide |
| A6 and A7 C8, 2019 on | 3.0 V6 with a turbo (EA839) | EA839 guide |
| A4, A5, Q5 B8 2.0T | EA888 2.0T | B8 2.0T tune |
What limits it
- The pulleys: The supercharger runs off the belt, so the pulleys set how fast it spins and how much boost it can make. A smaller supercharger pulley spins it faster. A dual pulley changes the crank pulley too.
- Heat: The intercoolers sit inside the supercharger and are cooled by water, through a heat exchanger at the front of the car. More boost means more heat for it to shed, which is why an upgraded heat exchanger is recommended from Stage 2 up.
- The transmission: The tune raises the rev limit to 7200. S tronic and Tiptronic cars can still upshift before 7200. Raising the shift points takes separate transmission software. A manual B8 S4 or S5 needs none. Questions about your car? Talk to us.
Pick your stage
| Stage | Needs | Recommended | Power |
|---|---|---|---|
| B8 S4 and S5 | |||
| Stage 1 | None | Exhaust | 438 hp / 370 lb-ft |
| Stage 2 | Supercharger pulley | Exhaust, heat exchanger | 455 hp / 385 lb-ft |
| Stage 3 | Dual pulley | Exhaust, heat exchanger | 462 hp / 430 lb-ft |
| C7 A6 and A7 | |||
| Stage 1 | None | Exhaust | 438 hp / 370 lb-ft |
| Stage 2 | Supercharger pulley | Exhaust, heat exchanger | 455 hp / 385 lb-ft |
| Stage 2+ | Dual pulley | Exhaust, heat exchanger | 462 hp / 430 lb-ft |
The GTS tunes for this engineShop the Audi B8 S4 / S5 3.0T tune →
Shop the Audi C7 A6 / A7 3.0T tune →
Dual pulley on a C7, or a 3.0T car not listed here? Talk to us first.
What the tune does
Sharper response with the factory lag taken out, better fuel economy, and the speed limiter removed. Every GTS calibration is written for a car with all of its factory emissions equipment in place.
How you get the tune
Both 3.0T tunes are done remotely, through the OBD port:
- The flash: Plug the GTS cable into the OBD port and a Windows laptop. We recommend a battery charger on the car during the flash. The flash itself usually takes 10 to 15 minutes. The cable is yours to keep for every tune after this one.
- Logs and revisions: Included at no extra cost. You drive, send us logs, and we adjust. Revisions usually come back the same day, and we tell you if one will take longer.
- Back to stock: Your original calibration is read and kept before anything is written, so the car can go back to stock whenever you want it to.
We never ask for remote access to your computer. How remote tuning works.